A:Â
Hello,
In the ownerâs manual, it is clearly explained.
CONNECTING THE WIRES:
- The posts on the relay are identified by numbers. (1,2,3,4).
- Install the wires from the winch on the posts of the relay.
- Red wire (+) on post # 3.
- Black wire (-) on post # 4.
- Connect the red wire from the winch (limit switch) with the green wire from the relay.
IDENTIFY THE IGNITION WIRE:
- Place the clip of the Hi/Low tester on the negative post (-) on the battery or a metal surface without any paint.
- Turn the ignition key to the position: Accessory.
- Insert the tip of the tester in a hole at the back of the starter (switch) make sure to touch the metal part of the wire (on most tractors, it is the A1 terminal on the ignition switch that is used for accessories. Before connection, verify with the Hi/Low tester).
- If the tester's light turns on, turn the ignition key to the position, Off. The light must turn off. You have identified the ignition wire, if not repeat the operation on another wire.
INSTALL THE CONTROL WIRE:
- Join the ignition wire and the red wire from the winch control with the instant connector.
- Connect the black wire of the winch control to the black wire on the relay.
- Connect the green wire of the winch control with the red wire of the winch (limit switch).
Thanks for shopping Sears.
